Vertical slab water mold casting machine
The water mold casting machine produced by the company is a new technical equipment combining traditional mold casting machine and modern continuous casting machine technology.
This equipment is especially suitable for the production of special-shaped and near-final products. The water mold casting machine has high yield rate, low loss of raw materials, and the recovery rate of molten steel can reach 95%---98%. The single casting has a large weight and high quality. The surface of the cast product is smooth and flat, and the geometric size is accurate. The work efficiency is high. Fast injection speed, rapid solidification and forming, multiple castings can be poured at one time, and demoulding can be completed at one time; simple and convenient operation, safe and reliable, reducing labor; high temperature demoulding can be achieved, castings can be hot-loaded furnace or directly rolled into rolling mill; investment The advantages of small and short payback period have solved the problem of small batches of multiple varieties of castings in the metallurgical industry, and fundamentally changed the casting and ingot casting processes of metallurgical enterprises.
1. Equipment name: Vertical slab water mold casting machine
Model specification: billet diameter 200*1000*2000mm
Total equipment weight: about 50 tons
2. Equipment configuration:
1. Before using the equipment, the equipment must be inspected; whether there is water leakage and whether the hydraulic pressure is normal. After checking, everything is normal before use.
3. Precautions for equipment use:
1. Before using the equipment, the equipment must be inspected; whether there is water leakage and whether the hydraulic pressure is normal. After checking, everything is normal before use.
2. Operators should undergo pre-job training. Familiar with the operating procedures before starting operation.
4, the operation process
1. Start the hydraulic system, open the mold, and lay the diversion refractory material. Requirements: Refractory bricks are laid flat and seamless, and kept at a level with the base; each group (4 holes) is aligned with a set of molds. (Figure 1)
After laying the refractory bricks, use an air gun to blow out the garbage inside the bricks. (Figure 2)
2. Clamp the mold and lock the safety. (Picture 3) and check whether the locking cylinder is working properly.
3. Close the mold and place the high temperature riser. Start the cooling system.
4. Product pouring. During the pouring process, the locking cylinder must remain in working condition. (Figure 4)
5. The pouring product is crystallized. Open the insurance, split the mold to lift out the poured product. (Figure 5)
Product Description
){kind=link}