| Customization: | Available |
|---|---|
| Application: | Universal, Industrial, Household Appliances, Car, Power Tools |
| Operating Speed: | Low Speed |
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
| Product Name | variable frequency adjustable speed three phase asynchronous motor |
| Motor Type | DC Motor,ACMotor,Stepper Motor,Asynchronous Motor ,Synchronous Motor (Electric machinery) |
| series | TPYM series |
| Operating speed | Constant Speed /Low Speed /Adjust Speed /High Speed Other |
| Rated voltage: | 380V |
| Rated power | 0.75 ~ 315KW |
| Reference frequency | 50Hz |
| Cooling mode | IC411 |
| Insulation class | F |
| Protection level | IP54 or IP55 |
| Altitude | no more than 1000 meters |
| Connection | 3kW and below for Y connection, 4kW and above for delta connection. |
| Basic structure forms | B3, B5, B35, B14, B34 |
| Application | YVF2 series motors are suitable for driving rolling, lifting, transportation, machine tools, printing and dyeing, papermaking, chemical industry, textile, pharmaceutical and other mechanical equipment requiring continuous and frequent positive and negative inversion, and can be used in conjunction with various frequency conversion power supply at home and abroad. |
| Maintenance method | Professional motor maintenance center motor maintenance process: cleaning stator and rotor - replacing carbon brush or other parts - vacuum F pressure dipping paint - drying - Calibration balance. 1. Use environment should be always dry, motor surface should be kept clean, air intake should not be hindered by dust, fibers and other obstacles. 2. When the thermal protection of the motor continues to operate, it should be ascertained whether the fault comes from the motor or the overload or the setting value of the protective device is too low. After eliminating the fault, it can be put into operation. 3, ensure that the motor is well lubricated during operation. The general motor runs for about 5000 hours, that is to say, lubricating grease should be added or replaced. When bearing overheating or lubricating deterioration is found in operation, the hydraulic pressure should change lubricating grease in time. When replacing grease, the old grease should be removed, and the oil groove of bearing and bearing cover should be washed with gasoline. Then ZL-3 lithium grease should be filled with 1/2 (2 poles) and 2/3 (4 poles, 6 poles and 8 poles) of the cavity between the inner and outer rings of the bearing. 4. When the life of the bearing is over, the vibration and noise of the motor will increase obviously. When the radial clearance of the bearing reaches the following value, the bearing should be replaced. 5, when removing the motor, it is OK to remove the rotor from the shaft extension or the non extension end. If it is not necessary to unload the fan, it is more convenient to take out the rotor from the non-axle extension end. When pulling out the rotor from the stator, the stator winding or insulation should be prevented from being damaged. 6. When replacing the windings, the form, size, turns and gauges of the original windings must be recorded. When these data are lost, they should be obtained from the manufacturer and the original designed windings should be changed at will, which often deteriorates one or several performance of the motor or even makes it impossible to use them. |
){kind=link}